Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.3 DHCPv4 client (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
334 Configuration Manual, 06/2016, C79000-G8976-C252-11
7.3.2.3
ip dhcp client mode
Description
With this command, you configure the type of identifier with which the DHCP client logs on
with its DHCP server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp client mode {mac|client-id<client-id>|sysname|pnio-name-of-station}
The parameters have the following meaning:
Parameter
Description
Range of values / note
mac
The client registers with its MAC ad-
dress
-
client-id
The client registers with the assigned
ID
-
client-id
Name of the assigned ID
max. 32 characters
sysname
The client registers with the assigned
system name
-
pnio-name-of-
station
The client logs in with the PROFINET
name. The name is assigned with the
PST tool.
-
Result
The registration mode of the DHCP client is configured.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English