Siemens SCALANCE XM-400 - Ipv6 Ospf Retransmit-Interval

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
612 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf priority
Result
The priority is reset.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You configure the priority with the
ipv6 ospf priority command.
You display the configuration with the
show ipv6 ospf interface command.
9.3.4.13
ipv6 ospf retransmit-interval
Description
With this command you specify the time after which packets whose receipt was not
confirmed are transferred again.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#