Siemens SCALANCE XM-400 - No Dot1 X Port-Control; Set Dot1 X Mac-Auth Mac-Addr Count

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
879
11.7.3.13
no dot1x port-control
Description
With this command, you reset the port control parameter of the authenticator to the default
value.
The default value is
force-authorized.
With this, data traffic is permitted without restrictions.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x port-control
Result
The port control parameter of the authenticator is reset to the default value.
Further notes
You configure the port control parameter with the dot1x port-control command.
You can display the status of this function and other information with the
show
dot1x
command.
11.7.3.14
set dot1x mac-auth mac-addr count
Description
With this command, you specify how many MAC addresses can be authenticated on the port
at the same time.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#