Siemens SCALANCE XM-400 - No Ntp Server; Ntp Time Diff

System time
5.2 NTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
164 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The connection to a server is configured on the NTP client.
Further notes
You delete the connection to a server with the no ntp server command.
5.2.3.2
no ntp server
Description
With this command, you delete the connection to a server on the NTP client.
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Syntax
Call up the command with the following parameters:
no ntp server <integer (1-3)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
integer
Number of the NTP server.
1 ... 3
Result
The connection to a server is deleted on the NTP client.
Further notes
You configure the connection to a server with the ntp server command.
5.2.3.3
ntp time diff
Description
With this command, you configure the time difference between the device and the NTP
server.