Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
637
no vrrp primary-ip
Description
With this command, you remove an IPv4 address from the virtual router.
Note
This command is available only with layer 3.
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli (config-vrrp-if)#
Call up the command with the following parameters:
no vrrp <vrid(1-255)> ipv4 <ucast_addr > [secondary]}]
The parameters have the following meaning:
Value for an IPv4 unicast address Enter a valid IPv4 unicast ad-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
The IPv4 address is removed from the virtual router.
You configure a VRRP interface with the interface command.
You assign IPv4 addresses to a virtual router with the
vrrp associated-ip command.
You display the IPv4 addresses with the
show vrrp interface - vrid command.