Siemens SCALANCE XM-400 - Show Ipv6 Rip Peer-Trig-Update-Interval; Show Ipv6 Rip Stats

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
694 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The information is displayed.
9.7.1.4
show ipv6 rip peer-trig-update-interval
Description
This command shows the configured timers.
Requirement
● Routing with RIPng is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 rip peer-trig-update-interval
Result
The information is displayed.
9.7.1.5
show ipv6 rip stats
Description
This command shows statistical information, e.g. the number of updates.
Requirement
● Routing with RIPng is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 rip stats