Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
97
Call up the command with the following parameters:
lldp{transmit|receive}
The parameters have the following meaning:
The sending of LLDP packets is ena-
Default: enabled
The receipt of LLDP packets is ena-
bled.
Default: enabled
Note
Enabling both options
Whe
n you call this command, you can only select one option.
If you want to enable both options, call up the command again.
Sending or receipt of LLDP packets is enabled.
You disable the sending or receipt of LLDP packets with the no lldp command.
With this command, you disable the sending or receipt of LLDP packets on the interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
no lldp{transmit|receive}
To Next Page
Loading...
Need help?
General