Siemens SCALANCE XM-400 - No Ipv6 Ospf

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
603
Further notes
You configure the router ID with the router-id command.
You disable OSPFv3 with the
no ipv6 ospf command.
You show the configuration of the OSPFv3 interface with the
show ipv6 ospf interface
command.
9.3.4.2
no ipv6 ospf
Description
With this command, you enable OSPFv3 on the interface.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● The router ID is configured.
● OSPFv3 routing is activated.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf
Result
The interface is removed from the area.
Further notes
You configure the router ID with the router-id command.
You enable OSPFv3 with the
ipv6 ospf area command.
You show the configuration of the OSPFv3 interface with the
show ipv6 ospf interface
command.