Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
604 Configuration Manual, 06/2016, C79000-G8976-C252-11
ipv6 ospf dead-interval
Description
With this command, you specify the time that can elapse before the neighbor router is
assumed to have "failed". This means that no more Hello packets were received from it
during this time.
Note
This command is available only with layer 3.
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
ipv6 ospf dead-interval <interval>
The parameter has the following meaning:
Interval in seconds 1 ... 65535
Default: 40
The value must be four times the hello interval.
The routers located on the same link must have the
The interval is specified.
You display the configuration with the show ip ospf interface command.
You enable OSPFv3 routing with the
ipv6 router ospf command.
You can reset the interval to the default with the
no ipv6 ospf dead-interval command.
To Next Page
Loading...
