Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
181
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN or VLAN range
-
vlan-range
Number of the addressed VLAN or
VLAN range
1 ... 4094
address
Keyword for a MAC address
-
aa:aa:aa:aa:aa:aa
MAC address -
interface
Keyword for a an interface description
-
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries of the MAC addresses table are displayed.
6.1.1.2
show mac-address-table dynamic multicast
Description
This command shows the table with the dynamic multicast MAC addresses assigned by the
device.
Note
The device does not learn any reserved multicast addresses, see als
o RFC 5771.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show mac-address-table dynamic multicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>]
[{interface<interface-type><interface-id>}]

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English