Siemens SCALANCE XM-400 - No Distribute-List

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
592 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.3.3.11
no distribute-list
Description
This command disables the filtering of the routing information according to a route map for
incoming routing information.
Note
This command is available only with layer 3.
Requirement
● OSPFv3 routing is activated.
● The router is an ASBR router.
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no distribute-list route-map <name(20)> in
The parameters have the following meaning:
Parameter
Description
Range of values / note
route-map
Keyword for a route map
-
name
Name of the route map
Maximum of 20 characters
in
Incoming routing information is fil-
tered.
-
Result
The filtering is disabled.
Further notes
You enable the filtering with the distribute-list command.
You enable OSPFv3 routing with the
ipv6 router ospf command.
You display the setting with the
show ipv6 ospf command.