Siemens SCALANCE XM-400 - Signaling Contact; The Show Commands; Show Signaling Contact; Commands in the Global Configuration Mode

Functions specific to SCALANCE
4.4 Signaling contact
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
151
4.4
Signaling contact
This section describes the commands relevant for working with the signaling contact.
4.4.1
The "show" commands
This section describes commands with which you display various settings.
4.4.1.1
show signaling contact
Description
This command shows the current configuration of the signaling contact.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show signaling-contact
Result
The current configuration of the signaling contact is displayed.
4.4.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.