Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
450 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp query-interval <value (1-31744) seconds>
The parameters have the following meaning:
Parameter
Description
Range of values / note
value
Length of the interval 1 ... 31744
Default: 125
seconds
Specified in seconds -
Result
The interval is defined.
Further notes
You reset the interval to the default with the no ip igmp query-interval command.
You display the setting and other information with the
show ip igmp global-config
command.
8.2.3.12
no ip igmp query-interval
Description
With this command, you reset the time interval at which the multicast router sends IGMP
queries to the default value.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ip igmp query-interval

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English