Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.6 DHCPv4 Relay Agent (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
366 Configuration Manual, 06/2016, C79000-G8976-C252-11
7.6
DHCPv4 Relay Agent (IPv4)
This section describes commands for the DHCP Relay Agent.
7.6.1
The "show" commands
This section describes commands with which you display various settings.
7.6.1.1
show dhcp server
Description
With this command, you display the IP addresses of the DHCP servers to which the device
forwards the frames.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global
Configuration mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show dhcp server
Result
The IP addresses of the DHCP servers are displayed.
Further notes
With the "ip dhcp server" command, you specify the IP addresses.
7.6.1.2
show ip dhcp relay information
Description
This command displays the DHCP relay agent settings for all or for a selected VLAN.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English