Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
722 Configuration Manual, 06/2016, C79000-G8976-C252-11
match next-hop ip
Description
With this command, you specify whether or not the filtering for a route map will be based on
the router (IPv4) to which the routing information is sent next.
Note
This command is available only with layer 3 (IPv4).
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Call up the command with the following parameters:
match next-hop ip <next-hop Ip address>
The parameter has the following meaning:
IPv4 address Enter the IPv4 address of the router to which the routing infor-
mation will be sent next.
The filter for the next router (IPv4) is created.
You delete the filter for the next router (IPv4) with the no match next-hop ip command.
You create a filter for the next router (IPv6) with the
match next-hop ipv6 command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
To Next Page
Loading...
Need help?
General