Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
223
Syntax
Call up the command with the following parameters:
private-vlan { primary | isolated | community }
The parameters have the following meaning:
Parameter
Description
Range of values / note
primary
With this type, you define a primary PVLAN.
The primary PVLAN uses the VLAN ID of the
VLAN.
-
isolated
With this type, you define a secondary PVLAN.
Only one device can exist in this secondary PVLAN.
The secondary PVLAN has a specific VLAN ID.
-
community
With this type, you define a secondary PVLAN.
The devices in this secondary PVLAN can com-
municate with each other via layer 2. The second-
ary PVLAN has a specific VLAN ID.
-
Result
The PVLAN is defined and the PVLAN type specified.
Further notes
You delete the configuration as a private VLAN with the no private-vlan command.
You display this setting with the
show vlan private-vlan command.
6.1.4.6
no private-vlan
Description
With this command, you delete the configuration as a private VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no private-vlan

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English