Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
440 Configuration Manual, 06/2016, C79000-G8976-C252-11
8.2.2.4
no ip igmp group-list
Description
With this command, you delete a multicast group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip igmp group-list <integer>
The parameter has the following meaning:
Parameter
Description
Range of values / note
integer
Number of the multicast group
1 ... 4294967295
Result
The multicast group has been deleted.
Further notes
You define a multicast group with the ip igmp group-list command.
You display the configured multicast groups with the
show ip igmp group-list command.
8.2.2.5
ip igmp limit
Description
With this command, you define the maximum number of multicast groups that can be
learned using IGMP on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English