Siemens SCALANCE XM-400 - Broadcast-Block; No Broadcast-Block

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
94 Configuration Manual, 06/2016, C79000-G8976-C252-11
3.1.13.3
broadcast-block
Description
With this command, you enable the blocking of broadcast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
broadcast-block
Result
Broadcast frames are blocked.
Further notes
You disable the blocking of broadcast frames with the no broadcast-block command.
3.1.13.4
no broadcast-block
Description
With this command, you disable the blocking of broadcast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no broadcast-block