Siemens SCALANCE XM-400 - Dot1 X Guest-Vlan Reset

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
873
Result
The ID of the guest VLAN has the value 1.
Further notes
You configure the guest VLAN ID with the dot1x guest-vlan vlan-id command.
You display this setting and other information with the show dot1x command.
11.7.3.5
dot1x guest-vlan reset
Description
This command removes MAC addresses from the guest VLAN. If you specify a MAC
address, only this MAC address is removed from the guest VLAN. If you use this command
without parameters, all MAC addresses are removed from the guest VLAN.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x guest-vlan reset [mac <aa:aa:aa:aa:aa:aa>]
The parameter has the following meaning:
Parameter
Description
Range of values / note
mac
Keyword for the MAC address
-
MAC address to be removed from the
guest VLAN.
aa:aa:aa:aa:aa:aa
Result
The specified MAC address or all MAC addresses are no longer assigned to the guest
VLAN.