Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
447
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp last-member-query-interval <value(1-255) tenths of seconds>
The parameters have the following meaning:
Parameter
Description
Range of values / note
value
Value for the time interval 1 ... 255
Default: 10
tenths of seconds
Specified in tenths of seconds
-
Result
The period of time is specified.
Further notes
You can reset the time to the default with the no ip igmp last-member-query-interval
command.
You display the setting and other information with the
show ip igmp global-config
command.
8.2.3.8
no ip igmp last-member-query-interval
Description
With this command, you reset the time during which the multicast router searches for further
clients after the last Leave message to the default value.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ip igmp last-member-query-interval

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English