Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
185
The static unicast MAC addresses are displayed.
show mac-address-table count
Description
With this command, you show the number of MAC addresses for all or a selected VLAN.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show mac-address-table count[vlan<vlan-id(1-4094)>]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
If you do not select any parameter from the parameter list, the total number of entries is
displayed for all VLANs.
The number of MAC addresses for the selected VLAN is displayed.
show subnet-vlan mapping
Description
This command shows the entries of a subnet VLAN table.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General