SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
775
This part contains the sections describing the functions for controlling and balancing network
load.
This section describes commands for controlling and restricting the data transmission rate of
an interface.
This section describes commands with which you display various settings.
show rate-limit output
Description
This command shows the packet rate for limiting the outgoing data stream of one or all
interfaces.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show rate-limit output[interface<interface-type><interface-id>]
The parameters have the following meaning:
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
To Next Page
Loading...
Need help?
General