Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
439
Result
IGMP is disabled.
Further notes
You enable IGMP with the ip igmp command.
You display the setting and other information with the
show ip igmp global-config
command.
8.2.2.3
ip igmp group-list
Description
With this command, you define a multicast group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp group-list <integer> <ip-address> <mask>
The parameters have the following meaning:
Parameter
Description
Range of values / note
integer
Number of the multicast group
1 ... 4294967295
ip-address
IP address of the multicast group
Specify the IP address.
mask
Subnet mask of the multicast group
Specify the subnet mask.
Result
The multicast group has been created.
Further notes
You delete a multicast group with the no ip igmp group-list command.
You display the configured multicast groups with the
show ip igmp group-list command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English