EasyManuals Logo

Siemens SCALANCE XM-400 Configuration Manual

Siemens SCALANCE XM-400
960 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #547 background imageLoading...
Page #547 background image
Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
547
Result
The filtering is enabled.
9.2.3.24
no distribute-list route-map
Description
This command disables the filtering of the routing information according to a route map for
incoming routing information.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no distribute-list route-map <name(1-20)> in
The parameters have the following meaning:
Parameter
Description
Range of values / note
name
Name of the routing table.
Maximum of 20 characters.
in
Incoming routing information is filtered.
-
Result
The filtering is disabled.
9.2.3.25
router id
Description
With this command, you specify the ID of the router.
Note
This command is available only with laye
r 3.

Table of Contents

Other manuals for Siemens SCALANCE XM-400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XM-400 and is the answer not in the manual?

Siemens SCALANCE XM-400 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XM-400
CategorySwitch
LanguageEnglish

Related product manuals