Siemens SCALANCE XM-400 - Router ID; Commands in the Interface Configuration Mode

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
601
9.3.3.20
router id
Description
With this command, you specify the ID of the router.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
router-id <IPv4-Address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
IPv4-Address Router ID Specify the ID in the IPv4 address format.
x.x.x.x
x = 0 ... 255
Result
The ID of the router is specified.
Further notes
You display the router ID and other information with the show ipv6 ospf interface
command.
9.3.4
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.