EasyManuals Logo

Siemens SCALANCE XM-400 Configuration Manual

Siemens SCALANCE XM-400
960 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #497 background imageLoading...
Page #497 background image
Layer 2 management protocols
8.8 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
497
8.8
MLD Snooping (IPv6)
This section describes commands for MLD snooping. MLD (Multicast Listener Discovery)
snooping only forwards multicast packets to the intended host instead of flooding all ports
with them.
8.8.1
The "show" commands
This section describes commands with which you display various settings.
8.8.1.1
show ipv6 mld snooping
Description
This command shows the information about MLD snooping for all or a selected VLAN.
Requirement
MLD snooping is enabled.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ipv6 mld snooping [Vlan <vlan id>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
Vlan
Keyword for a VLAN connection
-
vlan id
Number of the addressed VLAN
1 ... 4094
If you specify VLAN, the configuration of all VLANs is displayed.
Result
The information about MLD snooping is displayed.
Further notes
You enable MLD snooping with the ipv6 mld snooping command.

Table of Contents

Other manuals for Siemens SCALANCE XM-400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XM-400 and is the answer not in the manual?

Siemens SCALANCE XM-400 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XM-400
CategorySwitch
LanguageEnglish

Related product manuals