Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
691
Syntax
Call up the command with the following parameters:
ip rip send [demand] version (1 | 2 | 12 | none)
The parameters have the following meaning:
Parameter
Description
Range of values / note
demand
Updates are sent only when requested.
-
1
Only RIPv1 updates are sent. -
2
Only RIPv2 updates are sent.
-
12
RIPv1 and RIPv2 updates are sent.
-
none
No RIP updates are sent.
-
Result
It has been specified which RIP version outgoing updates need to have.
9.6.4.6
no ip rip send version
Description
This command specifies that there is no restriction relating to the version of outgoing RIP
updates. Updates according to RIPv1 and RIPv2 are sent.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameters:
no ip rip send version
Result
All RIP updates are sent.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English