Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
210 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Configures the port as a promiscuous port.
Promiscuous ports belong to a primary PVLAN. Connect
devices to promiscuous ports that are intended to communi-
cate with all other devices of the PVLAN.
GVRP must be disa-
bled on the port.
Configures the port as a host port.
Host ports belong to a secondary PVLAN. Connect devices
to host ports that are only intended to communicate with
certain devices of the PVLAN.
The operating mode for the private VLAN port is configured.
You display this setting and other information with the show vlan port config command.
You configure the interface as a switch port with the
switchport command.
You configure a host port with the
switchport private-vlan host-association command.
You configure a promiscuous port with the
switchport private-vlan mapping command.
switchport priority default
Description
With this command, you configure the priority default for the interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
switchport priority default <(0-7)>
The parameter has the following meaning:
Value for the priority default 0 ... 7
To Next Page
Loading...
