Siemens SCALANCE XM-400 - Whoami

Security and authentication
11.1 User management
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
805
Syntax
Call up the command with the following parameters:
change password <passwd>
The parameter has the following meaning:
Parameter
Description
Range of values / note
passwd
Value for the password Enter the password.
The entry depends on the password
policy.
The show password-policy command
shows which password policy is currently
being used.
Result
The password is changed.
Note
Changing the password in Trial mode
Even if you change the password in Trial mode, this change is saved immediately.
Further notes
You create a user with the user-account command.
You delete a user with the
no user-account command.
You show the created users with the
show user-accounts command.
You configure the password policy with the
password-policy command.
11.1.3
whoami
Description
This command shows the user name of the logged in user.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#