Siemens SCALANCE XM-400 - Ospfv2 (Ipv4); The Show Commands; Show Ip Ospf

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
512 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call the command without parameter assignment:
show ip protocol
Result
The current settings of the activated routing protocols are displayed.
9.2
OSPFv2 (IPv4)
This section describes the commands relevant for working with routing with OSPF.
9.2.1
The "show" commands
This section describes commands with which you display various settings.
9.2.1.1
show ip ospf
Description
This command shows information about routing with OSPF.
Note
This command is availa
ble only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip ospf
Result
The configuration for routing with OSPF is displayed.