Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
682 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Parameter
Description
Range of values / note
name
Name of the routing table.
Maximum of 20 characters.
in
Incoming routing information is filtered. -
out
Outgoing routing information is filtered.
-
Result
The filtering is enabled.
9.6.3.6
no distribute-list route-map
Description
This command disables the filtering of the routing information according to a route map for
incoming or outgoing routing information.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
no distribute-list route-map <name(20)> {in | out}
The parameters have the following meaning:
Parameter
Description
Range of values / note
name
Name of the routing table. Maximum of 20 characters.
in
The filtering for incoming routing infor-
mation is disabled.
-
out
The filtering for outgoing routing infor-
mation is disabled.
-
Result
The filtering is disabled.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English