Siemens SCALANCE XM-400 - Redistribute

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
544 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no redist-config <Network> <Mask>
The parameters have the following meaning:
Parameter
Description
Range of values / note
Network
Target address of the route.
specify the IP address.
Mask
Subnet mask of this route specify the subnet mask.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The information for the route is deleted.
Further notes
You create the information with the redist-config command.
9.2.3.21
redistribute
Description
With this command, you specify which known routes are distributed via OSPF.
Note
This command is available only with layer 3.
Requirement
● The router is an ASBR router.
● You are in the OSPF Router configuration mode.
The command prompt is:
cli(config-ospf)#