Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
265
spanning-tree bpdu-receive
Description
With this command, you enable or disable the BPDU receive status at the port.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
spanning-tree bpdu-receive{enabled|disabled}
The parameters have the following meaning:
BPDU packets are received at the port
BPDU packets are ignored at the port
The BPDU receive status is enabled or disabled.
You can display the status of this function and other information with the show spanning-tree
interface
command with the detail option.
spanning-tree bpdufilter
Description
With this command, you configure the BPDU transmit status for a port.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
To Next Page
Loading...
Need help?
General