To Next Page

To Previous Page

Layer 3 functions

9.3 OSPFv3 (IPv6)

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

577

9.3.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.

In Privileged EXEC mode, enter the

configure terminal command to change to this mode.

Commands relating to other topics that can be called in the Global configuration mode can

be found in the relevant sections.

You exit the Global configuration mode with the

end or exit command and are then in the

Privileged EXEC mode again.

9.3.2.1

ipv6 router ospf

Description

With this command, you enable routing with OSPFv3 and change to the Router configuration

mode.

Note

This command is available only with layer 3.

Requirement

● IPv6 routing is activated.

● You are in the Global Configuration mode.

The command prompt is as follows:

cli(config)#

Syntax

Call the command without parameter assignment:

ipv6 router ospf

Result

Routing with OSPFv3 is enabled.

You are now in the OSPFv3 router configuration mode.

The command prompt is as follows:

cli (config-ospfv3)#

Further notes

You disable routing with OSPFv3 with the no ipv6 router ospf command.

You enable IPv6 routing with the

ipv6 unicast-routing command.

Siemens SCALANCE XM-400 Configuration Manual

Other manuals for Siemens SCALANCE XM-400