Siemens SCALANCE XM-400 - Spanning-Tree Auto-Edge; No Spanning-Tree Auto-Edge

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
263
6.3.5.5
spanning-tree auto-edge
Description
With this command, you enable automatic discovery of a bridge connected to the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
spanning-tree auto-edge
Result
The automatic discovery of a bridge on the interface is enabled.
Further notes
The automatic discovery of a bridge on the interface is disabled with the no spanning-tree
auto-edge
command.
6.3.5.6
no spanning-tree auto-edge
Description
With this command, you disable automatic discovery of a bridge connected to the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree auto-edge