Siemens SCALANCE XM-400 - Show Ip Nat Service

Layer 3 functions
9.9 NAT (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
736 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call the command without parameter assignment:
show ip nat config
Result
The global NAT configuration is displayed.
Further notes
You enable NAT/NAPT for the entire device with the ip nat command in the Global
configuration mode.
You disable NAT/NAPT for the entire device with the
no ip nat command in the Global
configuration mode.
You delete the periods of time with the
ip nat timeout command.
You can reset the time periods to the default with the
ip nat timeout command.
9.9.1.2
show ip nat service
Description
This command shows static port translations (NAPT) for an interface with a service.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ip nat service
Result
The information is displayed.
Further notes
You configure static port translations for an interface with the ip nat service command.
You delete a configuration with the
no ip nat service command.