Layer 2 management protocols
8.8 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
498 Configuration Manual, 06/2016, C79000-G8976-C252-11
show ipv6 mld snooping forwarding-database
Description
This command shows the multicast forwarding entries for all or a selected VLAN.
● MLD snooping must be enabled globally and in the VLANs.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ipv6 mld snooping forwarding-database [Vlan <vlan id>]
The parameters have the following meaning
Keyword for a VLAN connection
Number of the addressed VLAN
If you specify VLAN, the configuration of all VLANs is displayed.
The multicast forwarding entries are displayed.
You enable MLD snooping with the ipv6 mld snooping command.
show ipv6 mld snooping groups
Description
This command shows the information about the MLD snooping groups for all or a selected
VLAN.
To Next Page
Loading...
Need help?
General