Siemens SCALANCE XM-400 - Network; No Network

Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
683
9.6.3.7
network
Description
This command enables the RIP protocol for an IP interface.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
network <ip-address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
ip-address
The IP address for which RIP will be
enabled.
Specify a valid IP address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
RIP is enabled for the specified IP interface.
9.6.3.8
no network
Description
This command disables the RIP protocol for an IP interface.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#