Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
219
Call the command without parameters:
no name
The name of the VLAN is deleted.
You assign the VLAN a name with the command name.
With this command, you generate a list that specifies the behavior of the interfaces and
replaces the existing VLAN configuration.
● Member Port (tagged port)
The interface is added permanently to the list of incoming and outgoing connections.
Tagged and untagged frames are transferred.
● Untagged Port
The interface transfers untagged frames. If the VLAN ID (PVID) is set, incoming untagged
frames are given a tag with the VLAN ID specified there. Received frames with a VLAN
ID are forwarded according to the VLAN ID. With outgoing frames, the tag with the VLAN
ID is removed.
● Forbidden Ports
This interface is not used for communication in a VLAN.
The "tagged port" and "untagged port" you specify with this command are used for outgoing
data traffic.
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#