Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
548 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
router-id <router ip address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
router ip address
IP address Enter the IP address of the router
or a value in the IP address for-
mat.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The ID of the router is specified.
Further notes
You display the router ID and other information with the show ip ospf interface command.
9.2.3.26
summary-address
Description
With this command, you assign an area ID an address range. The address range is used to
group the external routes.
Note
This command is available only with layer 3.
Requirement
● The router is an area border router (ABR)
● You are in the OSPF Router configuration mode.
The command prompt is:
cli(config-ospf)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English