Siemens SCALANCE XM-400 - Commands in the Interface Configuration Mode; Ip Pim Bsr-Candidate

Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
769
Result
The interface is not a static rendezvous point.
Further notes
You define an interface as a static RP with the rp-static rp-address command.
You display the static rendezvous points with the
show ip pim rp-static command.
9.10.5
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
Note
PIM does not support any router ports.
9.10.5.1
ip pim bsr-candidate
Description
With this command, you specify that the interface will become a candidate for the bootstrap
router.
A BSR coordinates the rendezvous points in a PIM network.
Requirement
● The interface is not a router port.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#