Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
231
Result
The load balancing policy is set.
Further notes
You can reset the setting for the load balancing policy to the default with the no port-channel
load-balance
command.
You can display the status of this function and other settings with the
show etherchannel
command.
6.2.2.2
no port-channel load-balance
Description
With this command, you reset the load balancing policy for the interconnected ports of the
previously defined port channels to the default.
The default value is
src-dest-mac.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no port-channel load-balance [<port-channel-index(1-8)>]
The parameter has the following meaning:
Parameter
Description
Range of values / note
port-channel-index
Number of the port channel
1 ... 8
If you do not enter a value for port-channel-index, the setting is used for all port channels.
Result
The load balancing policy is reset to the default value.
Further notes
You can change the setting for the load balancing policy with the port-channel load-balance
command.
You can display the status of this function and other settings with the
show etherchannel
command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English