Siemens SCALANCE XM-400 - No Vrrp Track Decrement

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
675
9.5.5.16
no vrrp track decrement
Description
With this command, you delete the assignment of interface tracking to a VRRP interface and
the value by which the priority is reduced..
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> track
The parameter has the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
Result
The assignment and the value by which the priority will be reduced is defined are deleted.
Further notes
You assign a VRRP interface to an interface tracking and configure the value by which the
priority is reduced with the command
no vrrp track.
You display the assignment and value of the priority with the command
show vrrp or show
vrrp interface
with the parameter detail.