Siemens SCALANCE XM-400 - Show Vlan Port Config

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
188 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call up the command with the following parameters:
show vlan learning params[vlan<vlan-range>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN or VLAN range
-
vlan-range
Number of the addressed VLAN or
VLAN range
1 ... 4094
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.
Result
The settings for the automatic learning of addresses are displayed.
6.1.1.11
show vlan port config
Description
This command shows the VLAN-specific information for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show vlan port config[{port<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
port
Keyword for a port
-
interface-type
Type of interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.