EasyManuals Logo

Siemens SCALANCE XM-400 Configuration Manual

Siemens SCALANCE XM-400
960 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
72 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Parameter
Description
Range of values / note
port
Keyword for a port description
-
interface-type
Type or speed of the interface Enter a valid interface
interface-id
Module no. and port no. of the interface
For information on names of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The unicast blocking settings for ports are displayed.
3.1.1.17
show usage
Description
With this command, you display the CPU and RAM usage as a percentage.
If the usage falls below or exceeds the displayed threshold values, the status changes
accordingly. With the
event config command, you can configure that you are informed of the
status change by a message.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show usage [{cpu|ram}]
The parameters have the following meaning:
Parameter
Description
Range of values/note
cpu
Display of the CPU usage and threshold
values
-
ram
Display of the RAM usage and threshold
values
-
If you do not specify any parameters, the usage of CPU and RAM is displayed.

Table of Contents

Other manuals for Siemens SCALANCE XM-400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XM-400 and is the answer not in the manual?

Siemens SCALANCE XM-400 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XM-400
CategorySwitch
LanguageEnglish

Related product manuals