Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.5 Ring redundancy and standby connection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
479
Result
The standby function is disabled.
Further notes
You enable the setting with the ring-redundancy standby command.
You can display the status of this function and other information with the
show ring-
redundancy
command.
8.5.6
Commands in the redundancy configuration mode
This section describes commands that you can call up in the Redundancy Configuration
mode.
In the Global Configuration mode, enter the
ring-redundancy configuration command to
change to this mode.
● If you exit the Redundancy Configuration mode with the
exit command, you return to the
Global Configuration mode.
● If you exit the Redundancy Configuration mode with the
end command, you return to the
Privileged EXEC mode.
8.5.6.1
ring ports
Description
With this command, you configure the ports of the ring redundancy manager or ring
redundancy client on a device.
●
Redundancy manager
– In the normal status, the network structure is operated via port. The other port is only
used by the ring redundancy manager for checking.
– If there is a disruption, the two parts of the ring operate via both ports.
●
Redundancy client
– The client forwards all frames.
Requirement
You are in the Redundancy configuration mode.
The command prompt is as follows:
cli(config-red)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English