Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
569
The parameters have the following meaning:
Parameters
Description
Range of values /
note
area
Keyword for the area ID
-
AreaID
Area ID Specify an ID
x.x.x.x
x = 0 ... 255
router
only shows information of the LSA type "Router" (type
2001)
-
network
only shows information of the LSA type "Network" (type
2002)
-
as-external
only shows information of the LSA type "AS External" (type
4005)
inter-prefix
only shows information of the LSA type "inter-area prefix"
(type 2003)
-
inter-router
only shows information of the LSA type "inter-area router"
(type 2004)
-
intra-prefix
only shows information of the LSA type "intra-area prefix l"
(type 2009)
-
link
only shows information of the LSA type "link" (type 2008)
-
nssa
only shows information of the LSA type "type-7 LSA" (type
2007)
-
detail
shows Information in detail
HEX
shows Information in hexadecimal format
If you do not select any parameters from the parameter list, the entire content od the
database is shown.
Result
The information is displayed.
9.3.1.3
show ipv6 ospf areas
Description
This command shows information on the areas.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English