Siemens SCALANCE XM-400 - No Ip Igmp Immediate-Leave; Ip Igmp Last-Member-Query-Interval

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
446 Configuration Manual, 06/2016, C79000-G8976-C252-11
Further notes
You configure the IGMP version with the ip igmp version command.
You enable "Explicit Tracking" on an interface with the
ip igmp explicit-tracking
command.
You disable the "Immediate Leave" function on an interface with the
no ip igmp immediate-
leave
command.
You display the setting and other information with the
show ip igmp global-config
command.
8.2.3.6
no ip igmp immediate-leave
Description
With this command, you disable "Immediate Leave" function on an interface.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ip igmp immediate-leave
Result
Die "Immediate Leave" function is disabled on the interface.
Further notes
You enable the "Immediate Leave" function on an interface with the ip igmp immediate-leave
command.
You display the setting and other information with the
show ip igmp global-config
command.
8.2.3.7
ip igmp last-member-query-interval
Description
With this command you specify the period of time in which the multicast router searches for
further clients that want to receive a multicast after the last Leave message.