Siemens SCALANCE XM-400 - Wbm; The Show Commands; Show Web-Session-Timeout

Functions specific to SCALANCE
4.2 WBM
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
146 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call the command without parameter assignment:
write
Result
The current device configuration has been copied to the formatted PLUG.
4.2
WBM
On the device, you can limit the time available for access with Web Based Management. If
no entry is made for a specific time, the WBM session is closed.
This section describes commands relevant for the configuration of this feature.
4.2.1
The "show" commands
This section describes commands with which you display various settings.
4.2.1.1
show web-session-timeout
Description
This command shows the timeout setting for the WBM.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show web-session-timeout
Result
The timeout setting for the WBM is displayed.