Siemens SCALANCE XM-400 - Rmon; The Show Commands; Show Rmon

Diagnostics
12.5 RMON
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
934 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The monitor session is deleted.
Further notes
You display the configuration settings with the show monitor session command.
You configure and start mirroring of a port with the
monitor session command.
12.5
RMON
The RMON function provides commands with which variables of the Management
Information Base (MIB) can be monitored for violation of limit values and to store or forward
these events in the following ways:
● Entry in the local log
● Sending as SNMP trap
● Transfer to the Syslog server
● Transfer to a network management station using SNMP
12.5.1
The "show" commands
This section describes commands with which you display various settings.
12.5.1.1
show rmon
Description
This command shows the settings of the remote monitoring function.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show rmon [statistics [<stats-index (1-65535)>]] [alarms] [events] [history [history-
index (1-65535)] [overview]]